Carburettor Nightmare.x
#1
Posted 05 March 2017 - 07:58 pm
Can anyone direct me to a diagram of how how the hoses run please? I'm very visual, I now know that in future I should take pictures!
Ps I am not blowing kisses! Jeez, I miss pressed my phone! Lol
#2
Posted 05 March 2017 - 08:19 pm
OKAY, so newbie at tinkering. Took carbs off, tank off, fuel tap and now so many hoses I have no idea what I'm doing.
Can anyone direct me to a diagram of how how the hoses run please? I'm very visual, I now know that in future I should take pictures!
Ps I am not blowing kisses! Jeez, I miss pressed my phone! Lol
Do you have a Haynes manual? Most of the toobs go back where they land. Not too much chance of getting anything mixed up though.
Studley Ramrod is the carb guru.
Where are you? Maybe someone local can assist......
#3
Posted 05 March 2017 - 08:26 pm
there's yam manuals knocking around and they show all routing, cables, hoses etc
"As I Lay Rubber down to street, I pray for traction I can keep. But if I skid and begin to slide, please dear god protect my ride"
Mods; Oil pressure switch, neoprene rear inner mudguard, scottoiler, highway pegs, fenda extenda, 1999 carbs and airbox, Kais suspension setup, later clutch springs, LED lamps, Metmachex swingarm, Hagon Shock, Oxford heated grips, 4 way fused accessory Bus, 17" 3CV front wheel, Michellin R6 tyres, GPS speedo, 5' ignition advance.
#4
Posted 05 March 2017 - 09:54 pm
I've not seen a diagram showing routes for ALL the hoses for a mk1. Might help if you could throw some pics up showing us what you need help with.
The Haynes manual should help you locate some of them, as will the mk1 parts fiche.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#5
Posted 06 March 2017 - 09:11 am
Can't help with yer carbs but, - Hello
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
#6
Posted 06 March 2017 - 11:53 am
Oh and hello!
#7
Posted 06 March 2017 - 01:41 pm
#8
Posted 07 March 2017 - 02:14 am
This is for a US/California model, but it may help: http://www.cmsnl.com...slist/B-09.html
The parts fiche on boats.net is also helpful (http://www.boats.net...ETOR/parts.html ):
#9
Posted 15 May 2019 - 08:44 am
Hi all, I have a similar problem. Pulled carbs off long time ago and currently refitting. There are two tee pieces, one is fuel in (with filter in the tee) and another beneath it, part # 43 in the first link above. It shows a pipe bending down, is this just a drain?
Thanks
#10
Posted 15 May 2019 - 08:55 am
Yes.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#11
Posted 15 May 2019 - 09:13 am
Thanks Studley, wasn't too sure as there is a drain off each bowl (smaller dia tube)
#12
Posted 15 May 2019 - 06:17 pm
It might be a breather/drain-off.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#13
Posted 03 June 2019 - 10:26 am
Hi again, another question re the carbs. Got bike running today using tank hanging above gravity feeding direct to carb, all good. But when I opened up the throttle while running only the right hand slide opened/fluttered. Assume they should both open and be in sync?
Is this likely to be due to a damaged or incorrectly fitted diaphram?
Had a bit of a mission to get it reassembled, not helped by the fact that it had all been apart for a few years.
#14
Posted 03 June 2019 - 04:51 pm
It could be. With the engine stopped, push the black slides up in turn, there should be slight resistance.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users