8 votes
seems to like Carpe
Posted 16 September 2019 - 12:10 pm
usually my windscreen is on brackets(selfmade) and higher(separeted from original windscreen) I've removed them and bolted the extension lower because I expect some offroading.
Bike looks very good!
Could you show us these selfmade brackets?
I'm curious how you've done that.
Wind protection is always a pretty hot item on a TDM 
Carpe Addict
Posted 17 September 2019 - 07:25 pm
really likes Carpe
Posted 18 September 2019 - 11:05 am
Replace my bent handlebar to Renthal 756. Became a little bit wider.
Next going to thread M16x1.5 and install original heavy ends.
has been here 4ever
Posted 18 September 2019 - 11:25 am
Replace my bent handlebar to Renthal 756. Became a little bit wider.
Next going to thread M16x1.5 and install original heavy ends.
are those the same form as the originals? If so what are the benefits?
"As I Lay Rubber down to street, I pray for traction I can keep. But if I skid and begin to slide, please dear god protect my ride"
Mods; Oil pressure switch, neoprene rear inner mudguard, scottoiler, highway pegs, fenda extenda, 1999 carbs and airbox, Kais suspension setup, later clutch springs, LED lamps, Metmachex swingarm, Hagon Shock, Oxford heated grips, 4 way fused accessory Bus, 17" 3CV front wheel, Michellin R6 tyres, GPS speedo, 5' ignition advance.
really likes Carpe
Posted 18 September 2019 - 11:45 am
As for me the form is very close to original. About 20-30mm wider.
OEM 25-30 euro more expensive - this is my benefit
Sponsored by AutoGlym
Posted 18 September 2019 - 05:54 pm
I did this today
69241330_713040435827029_6485501613115965440_n.jpg 103.69KB
0 downloads
70256306_496941541090920_8515019706543898624_n.jpg 140.07KB
0 downloads
70512597_2393663990749481_6173775871774556160_n.jpg 120.94KB
0 downloads
70846121_1104933209703923_6235878315735908352_n.jpg 97.85KB
0 downloads
is it Jizzy Rascal time yet.....?
Posted 19 September 2019 - 01:24 pm
I did this today
Cats, whas goin on with those lever nuts and bolts, clutch side looks dome topped in one pic and ground down in another pic. Also the brake lever one is a noice looking stainless allen dome head. How can you sleep at night without the required symmetry!
spyball alarm/immob, bluespot brake calipers and Stainless hoses, Fournales air adjustable shock with Remote Resevoir, forks raised 10mm thru yokes, racetech linear fork springs in 15 wt oil, Kappa wingrack/luggage, heated grips, Kedo handguards, dual heat controller to power heated jacket liner and or pants!!, Stebel 136DB horn, K&N air filter, colour matched Baglux tank cover (magnetic tank bag modified to fit cover), osram +50% headloight bulbs, headlight protector,"NitramSpecial" parking loight, tail light indicators all running on LED's & incorporate "Lite Buddies", MK7 Scottoiler fitted, taller screen, 2-2 stainless steel CCC's, Devil stainless down pipes. MKI Renntec engine crash bars & sump guard.
engine changed july 2007 on a dyno run it made 79.1BHP / Torque 59.9Had a brief flirtation with a 1999 MKIIa but it blew an exaust valve on the M5 so was sold on to be repaired.
I loike tay and hang sangwiches !
www.kenhogantreeservices.co.uk
http://s33.photobuck...77/wickla/?sc=6
http://reg.imageshack.us/v_images.php
has been here 4ever
Posted 19 September 2019 - 01:48 pm
The Blue One : 2004 model owned 2010-2018 much loved, much missed and now living with a man in Scotland
The Black One : 2010 Model Registered 2013 owned 2018 - present.Beowulf Cans. Renthal 755s Grip Puppies,15w fork oil,DL650 handguards,givi engine bars,led spotlights,gipro gear indicator,shortened dogbones,LeeHenty CSM kit and stainless bits,Topsellerie seat,MRA Xcreen,grip puppies.PC III (dynoed). K&N airfilter,Fenda extenda.
Monkey Boys Monkey
Posted 19 September 2019 - 02:57 pm
Cats, whas goin on with those lever nuts and bolts, clutch side looks dome topped in one pic and ground down in another pic. Also the brake lever one is a noice looking stainless allen dome head. How can you sleep at night without the required symmetry!
lol
Prolly won't see 'em with the handguards fitted. 
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
full o shoite
Posted 19 September 2019 - 05:34 pm
Shabby
2002 TDM900 Yellow
Carpe Addict
Posted 24 September 2019 - 06:33 pm
20190924_143447.jpg 96.07KB
2 downloads
is it Jizzy Rascal time yet.....?
Posted 24 September 2019 - 07:48 pm
Managed to Lose a bolt holding the Front Brake caliper on way to work this morning
fooking scary noise and shuddering
So got creative for the journey Home20190924_143447.jpg
Ordered a new set from Fowlers
Must remember to double check that I've actually tightened properly ALL Bolts in future - cos finger tight is not enough
FWR tyres in Kennington did this to my TDM back in 2002 after fitting new hoops and both bolts came out, brake caliper was hanging down suspended by the brake hose so when i applied the front brake the brake fluid followed the path of least resistance and did nothing to slow my progress thru a sweeping left hander with a buxom pillion on board so the boike stood bolt uproight and i took the chance of running across the curve and into a bramble hedge. The boike remained upright and we were fine but had to have us and the TDM recovered back to south London. I now remove and refit my own wheels.
spyball alarm/immob, bluespot brake calipers and Stainless hoses, Fournales air adjustable shock with Remote Resevoir, forks raised 10mm thru yokes, racetech linear fork springs in 15 wt oil, Kappa wingrack/luggage, heated grips, Kedo handguards, dual heat controller to power heated jacket liner and or pants!!, Stebel 136DB horn, K&N air filter, colour matched Baglux tank cover (magnetic tank bag modified to fit cover), osram +50% headloight bulbs, headlight protector,"NitramSpecial" parking loight, tail light indicators all running on LED's & incorporate "Lite Buddies", MK7 Scottoiler fitted, taller screen, 2-2 stainless steel CCC's, Devil stainless down pipes. MKI Renntec engine crash bars & sump guard.
engine changed july 2007 on a dyno run it made 79.1BHP / Torque 59.9Had a brief flirtation with a 1999 MKIIa but it blew an exaust valve on the M5 so was sold on to be repaired.
I loike tay and hang sangwiches !
www.kenhogantreeservices.co.uk
http://s33.photobuck...77/wickla/?sc=6
http://reg.imageshack.us/v_images.php
Carpe fan
Posted 24 September 2019 - 09:17 pm
2002 TDM 900 Red/Yellow Cocktail (it's yellow)., biggified some
Sponsored by AutoGlym
Posted 25 September 2019 - 07:56 am
These arrived after I got a refund. Sat there for ages until Monday when I found 10 L brackets in Lidl for £2.
Need a switch and to move the RHS in a bit but I'm well pleased and how they fit
71069962_434479227178934_5995653038159691776_n.jpg 79.15KB
0 downloads
71379011_676888886130013_6748211040191774720_n.jpg 113.07KB
0 downloads
71851990_709501232899449_2324760416007225344_n.jpg 61KB
0 downloads
Carpe Addict
Posted 25 September 2019 - 07:40 pm
These arrived after I got a refund. Sat there for ages until Monday when I found 10 L brackets in Lidl for £2.
Need a switch and to move the RHS in a bit but I'm well pleased and how they fit
Carpe groupie
Posted 26 September 2019 - 08:21 am
When you wire them up, can you do a write up.... i have tge same lights, bought them ages ago, just havent got round to fitting them.. not too sure if a relay is required or not
Cheers
Chris
Fit the relay, I tapped into the dims but also fitted a switch on the handlebars so I can switch them off if I need to, check back on a few of my posts for pics on the lights working
Sir Cumference
Posted 26 September 2019 - 08:33 am
Flip MRA touring screen thingy fitted.
Waiting for cable for electrical enhancements..
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
Sponsored by AutoGlym
Posted 27 September 2019 - 08:10 am
chrisbee.
Had a set on the previous bike. No relay. unscrew the alloy ring and you will find the smallest LED known to man. They were bright too
DSC00368.JPG 241.6KB
0 downloads
Just won't go.
Posted 27 September 2019 - 09:26 am
Nice little spots, where did you get them and how many beer tokens?
Current toys: '99 XT600E, 2000 4TX, '82 Princess 30DS (where the username comes from), No longer a '03 Fazer thou.
Save the planet, it's the only one with beer!
Carpe Addict
Posted 27 September 2019 - 08:17 pm
7DA24DB1-6297-41F7-B0D6-8FE127A0DA56.png 977.74KB
0 downloads
0 members, 0 guests, 0 anonymous users
