There's a thread somewhere about these centre stands from Poland, Muddy, AliG and I clubbed in together to get 3, and that's what we did to our TDMs today
They arrive well packed and with all the bits n bobs needed.
DSC_0631.JPG 188.51KB 1 downloads
It's recommended that the exhaust headers are loosened or removed to allow access for the fixing plate.Fine for my bike (all shiney n new), but for those with exhaust header nut issues (you know who you are) , we found that we could access the fixings by removing the exhaust cans and stressing the pipes to give just enough room to get the bolts in and tightened up.
DSC_0657.JPG 118.16KB 1 downloads
DSC_0637_1.jpg 128.01KB 1 downloads
The bolt arrowed caused us some serious problems (seen here on my bike) as it is on the dirty side and the threaded hole was found to be full of crud on Muddy's and Ali's bikes, and with the exhausts in the way, well they are a PITA. The solution appears to be; center bolt to hold the weight and the left bolt fitted first.
All in all this a class bit of kit, which appears to be solidly made and damn good value.
Simple to fit, if a bit fiddly (OK a lot fiddly if the headers are an issue), and, I think, well designed.
Here's the link to RMG's website http://www.rm-g.pl/y...alna-podstawka/
Attached Files
Edited by TDMick, 07 June 2015 - 04:30 pm.