What Have You Done To Your Tdm Today?
#4101
Posted 29 May 2020 - 07:48 pm
#4102
Posted 30 May 2020 - 02:52 pm
Earlier this week new tires, chain & sprockets, so looking forward to 200km spin tomorrow.
But now - beers 😎
Edited by Bjørge, 30 May 2020 - 02:53 pm.
#4103
Posted 30 May 2020 - 03:00 pm
#4104
Posted 30 May 2020 - 03:08 pm
Bought some Scottoil.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#4105
Posted 30 May 2020 - 03:10 pm
Done nowt to the TDM but got the XT out fer a wee blat, fired up first press of the button and ran nice, now to sorn it....
Current toys: '99 XT600E, 2000 4TX, '82 Princess 30DS (where the username comes from), No longer a '03 Fazer thou.
Save the planet, it's the only one with beer!
#4106
Posted 30 May 2020 - 04:09 pm
Squeezed my lard ass past the TDM to get verniers & selection of 24mm spanners
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
#4107
Posted 30 May 2020 - 10:53 pm
The Blue One : 2004 model owned 2010-2018 much loved, much missed and now living with a man in Scotland
The Black One : 2010 Model Registered 2013 owned 2018 - present.Beowulf Cans. Renthal 755s Grip Puppies,15w fork oil,DL650 handguards,givi engine bars,led spotlights,gipro gear indicator,shortened dogbones,LeeHenty CSM kit and stainless bits,Topsellerie seat,MRA Xcreen,grip puppies.PC III (dynoed). K&N airfilter,Fenda extenda.
#4108
Posted 31 May 2020 - 05:36 pm
Removed engine bars ready for alterations and additions tomorrow - otherwise AKA welding on some aux lamps brackets & repaint
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
#4109
Posted 31 May 2020 - 06:03 pm
Fitted my Scottoiler, well, most of it, just need a few cable ties. Also cleaned the chain and rear wheel.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#4110
Posted 31 May 2020 - 06:14 pm
#4111
Posted 01 June 2020 - 08:38 am
Got the clutch working, sanded & polished top case clear coat.
Earlier this week new tires, chain & sprockets, so looking forward to 200km spin tomorrow.
But now - beers 😎
Bike runs good - measured 4.35L/100km (65mpg) mainly on back roads at low speed. A slight leak from fork seals stopped throughout the trip, but fork oil needs change. Pushing bars violently down causes a full 3 down/up waves😐
Also, a small oil leak from lower left side of engine, hopefully just alternator cover
#4112
Posted 01 June 2020 - 02:39 pm
quick paint of the engine not the best but all one colour went for mot pass, fitted bar risers , got a fuel leak think its the reinforced petrol pipe i used to redo them last year wasn't really happy with it at the time but forgot need to get 7mm is it single wall hose
any good suppliers of a couple of meters
#4113
Posted 01 June 2020 - 05:46 pm
quick paint of the engine not the best but all one colour went for mot pass, fitted bar risers , got a fuel leak think its the reinforced petrol pipe i used to redo them last year wasn't really happy with it at the time but forgot need to get 7mm is it single wall hose
any good suppliers of a couple of meters
i used carrot cycles. you pay for P&P so its best to get loads of the stuff.
They also do special cables to order. I had my speedo cable for a 50cc gilera mate to another make speedo
checked my oil pumps today for wear. a little scoring on the feed pump, but all within specs so happy with that.
Just awaiting piston coating and rings etc (next week I believe)
just messed about with rear cup and cone bearings my cycle, what a pain to do took an hour to get right, off and on the bike etc
"As I Lay Rubber down to street, I pray for traction I can keep. But if I skid and begin to slide, please dear god protect my ride"
Mods; Oil pressure switch, neoprene rear inner mudguard, scottoiler, highway pegs, fenda extenda, 1999 carbs and airbox, Kais suspension setup, later clutch springs, LED lamps, Metmachex swingarm, Hagon Shock, Oxford heated grips, 4 way fused accessory Bus, 17" 3CV front wheel, Michellin R6 tyres, GPS speedo, 5' ignition advance.
#4114
Posted 01 June 2020 - 06:14 pm
Engine bars modified and painted - will fit em Wednesday as a TDM 400miles round trip planned 4 tomorrow.
Wound one notch off fork spring pre-load cos the spannerwork has sprained my 9er wrist - it's gone all limp.
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
#4115
Posted 01 June 2020 - 07:27 pm
Scottoiler fitted. Will go for a test ride tomorrow.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#4116
Posted 02 June 2020 - 06:02 pm
En route to Harley shop in Uppingham - had a meet up with SR for sausage n egg bun washed down with coffees at the Green Hut nr Ollerton. Nice ole chat and a table away cops were the worst at social distancing today (yeah yeah they sit next to each other all day - just not in foursomes).
I forgot to look at your new chain oiler today Ian - next time.
Bill's HD not PXd and another fancy Electraglide remained in the shop. Nice day for a ride tho
Fuel 214 miles to last bar flashing - averaged 56mpg.
Had a 360 not 400 mile ride out. Airhawk had my butt complaining at 320miles.old age creeping up - I feel that 500 miles may be my maximum (long) day limit now.
Still had a grin on my face...........
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
#4117
Posted 02 June 2020 - 06:19 pm
Nice to meet up with you and Bill, pity he didn't get the newer Harley as I know he was looking forward to moving up in engine size. Next time maybe ? Yeah, cops all over the place, glad we weren't doing the flour meetup.
Mk2a 2000 in Silver. Top end Refurb @ 41100 miles, Scottoiler, Renthal Road High Bars, Up & Back Bar Risers, Bellypan, DL650 Handguards, Capt. Picard Bar Ends, House of Henty SS Wheel spacers, New Seat Cover Fitted. 58 MPG !! Now owned by chrisbee ! Studley's mk2a Bloggerydoodaah ! Photos of my first MK1 Photos of my MK2a TPLQHCSRSFC No. 1 Fan
#4118
Posted 02 June 2020 - 08:03 pm
it's gone all limp.
Never had spanner twirling do that before.
#4119
Posted 03 June 2020 - 07:37 am
Depends on the size of the nuts Lee (although they are used less often now )
Single-handedly reviving the Wave.
2008 reg. Black TDM 900 ABS
#4120
Posted 05 June 2020 - 09:36 am
Changed fork oil, as suspension had gone very sloppy. And, yes, oil was green/violet/grey, but still had the consistence of oil, not the vinegar like liquid I have seen before. Put in new oil, and thought "hmmm..." an went to bed.
Next moring, right before a work trip on the bike, it struck me: "Bloody hell, the dampening rods were not attached!" - and spent 20 mins undoing bars, fork caps - connected the rods, and I was good to go.
How did that happen ? I don't know, but it might be that when I last disassembled them, I forgot to tighten the rod nuts. I believe they were screwed all the way down on threads (but I'm not 100% sure, I was in a hurry). If so, they must have unwinded themselves.
I feel like an idiot
Anyone experienced "self-detached" damper rods ?
But - the bike runs beautifully !!! Also tightened head bearings. Now it's a proper dream. The fork (with Gold Valves) is just so much better than the now gone 9er (with emulators). Took it 200kms yesterday with a big grin on my face.
Asked the wife last night; "You know I have an MC savings account after selling the 9er? I just wonder what to do with it - I certainly don't need a new bike"
Edited by Bjørge, 05 June 2020 - 09:37 am.
2 user(s) are reading this topic
0 members, 2 guests, 0 anonymous users